$14.95 Flat Rate Postage

AEM One Gallon Tank Kit with Conductive Fluid Level Sensor / 30-3321

$139.95
AUD Inc GST

or four payments of $34.99 with

The AEM Water/Methanol 1 Gallon Tank can be used with nearly any water methanol kit using 1/4" OD hose. The tank includes a high tech conductive low fluid level indicator with a positive lock connector and color matched wires to the wiring harness. It is an ideal upgrade to tank-less systems or competitor systems that supply tanks less than one gallon. Comprehensive hardware for mounting is included. Dimensions: 10” Tall x 8.5” wide x 4.25” deep.

Important Safety Notice Regarding Methanol

AEM strongly recommends that users never exceed a 50% methanol concentration when using any AEM Water Methanol system or component.

All AEM Water/Methanol injection systems and components (pump, lines, fittings, filter, flow sensor, tank, and nozzles) are 100% chemically compatible with methanol. However, for safety reasons we strongly recommend that users never use more than a 50% methanol concentration in our systems.

Methanol is a toxic and highly flammable chemical. 100% Methanol ignites easily and burns vigorously with an almost undetectable flame. Methanol can be absorbed through the skin and even small amounts can cause blindness or even death. Using this fluid at high pressures, without dilution, in an under-hood environment with nylon lines and push-to-connect fittings is very unsafe. The performance advantages of using greater than 50% methanol concentrations are small, if they exist at all. However, the safety issues are very real and far outweigh any perceived benefit of running high concentrations of methanol.

WARNING!

Improper installation and/or adjustment of this product can result in major engine/vehicle damage. For technical assistance visit our forum or visit our dealer locator to find a professional installer/tuner near you.

Note: AEM holds no responsibility for any engine damage or personal injury that results from the misuse of this product, including but not limited to injury or death caused by the mishandling of methanol.

Note: FOR OPTIMUM RESULTS, ALL WATER/METHANOL INJECTION SYSTEMS AND GAUGES SHOULD BE RUN WITH AN AEM INLINE FILTER (AEM PART #30-3003)

Brand
AEM