HALTECH PLUG 'N' PLAY ADAPTOR HARNESS ONLY SUIT ELITE 2500 - FORD COYOTE 5.0, BOSCH EV1 INJECTORS (EARLY CAM)
The fastest and most cost effective way to wire your race car or engine conversion! Simply connect a handful of labelled wires and this plug and Play product allows you to be up and running in just a few hours.
- Efficient Haltech Plug'n'Play product that allows you to be up and running in just a few hours.
- Quick start guide will walk you through installation of the Haltech Plug'n'Play harness into your vehicle.
- Guide is accompanied by the full ECU manual and Software located on the CD or USB key provided with the ECU to refer to while completing your installation and configuration.
- Harness when installed in conjunction with a Haltech Elite ECU opens the door to virtually limitless performance modification and tuning of your vehicle.
- Programmable systems allow you to extract all the performance from your engine by delivering precisely the required amount of fuel and ignition timing that your engine requires for maximum output under all operating conditions.
- Terminated engine harness with fuse block, firewall grommet, pre-wired HPI8 15amp high power ignition module.
- Ford Coyote V8 (Early Style Cam Solenoid - Small single offset keyed connector, Manual Transmission Only)
- Supports DBW and quad variable cam timing.
- WBC1/2 CAN O2 Wideband Controller ready (Controller and sensor(s) not included)
- Requires modification for fitment to supercharged Cobra Jet version.
- Ignition module is NOT included. Please order HT-020040 if required.
- INJECTOR CONNECTOR: Bosch EV1