HALTECH PLUG 'N' PLAY ADAPTOR HARNESS ONLY SUIT ELITE 2500 - GM GEN III LS1/LS6 (LS2/3 DBW RETROFIT READY)
The fastest and most cost effective way to wire your race car or engine conversion! Simply connect a handful of labelled wires and this plug and Play product allows you to be up and running in just a few hours.
- Efficient Haltech Plug'n'Play product that allows you to be up and running in just a few hours.
- Quick start guide will walk you through installation of the Haltech Plug'n'Play harness into your vehicle.
- Guide is accompanied by the full ECU manual and Software located on the CD or USB key provided with the ECU to refer to while completing your installation and configuration.
- Harness when installed in conjunction with a Haltech Elite ECU opens the door to virtually limitless performance modification and tuning of your vehicle.
- Programmable systems allow you to extract all the performance from your engine by delivering precisely the required amount of fuel and ignition timing that your engine requires for maximum output under all operating conditions.
- Terminated engine harness with fuse block, firewall grommet.
- Holden/GM Gen III LS1/LS6 V8 (Manual Transmission Only)
- Ready for Retrofit of a GEN IV LS2/3 DBW throttlebody.
- Common US style Delco/Bosch GM alternator connector. Pre-wired to connect directly to OEM 7 Pin Coil Harness Connector.
- Please confirm your alternator connector (See the product quick start guide) and order an alternator adaptor if required. (HT-040090 or HT-040090)
- Ignition coils and harnesses are NOT included, Please order 8 x HT-020102 and/or HT-045657 if required.
- WBC1/2 CAN O2 Wideband Controller ready (Controller and sensor(s) not included)
- INJECTOR CONNECTOR: Bosch EV1 (per factory)